Enter a full or partial part number here to search for product datasheets.
Keep current with Connor-Winfield's latest products, technologies and industry news.
View archived product releases here.
The FT9-TFC Series module represents a fresh approach to precision timing offering two synchronized clock outputs when locked to an incoming 1PPS signal from a GNSS receiver, all in a small 9mm x 9mm form factor.
FT9-CC Series module offers advanced high precision frequency control with two synchronized and translated clock outputs when connected to an incoming 10 MHz MCLK signal.
This new Temperature Sense Enabled (TSE) OH20-TSE 10MHz OCXO module is designed to meet the demanding requirements for a wide range of precision timing applications.
The OH4 14 pin DIP series OCXO is an SC-cut crystal based oscillator designed specifically to be used in conjunction with a low filter bandwidths from < 1 mH to 0.1 Hz for compliance with T1-based hierarchy specifications such as ITU-T G.8262 Option 1 and 2 ECC, ITU-T G.8263, ITU-T G.813 Option 1 and 2 SEC, Stratum 3 and 3E for Sonet, IEEE1588 and Synchronous Ethernet.
The TL602 and ML602 are temperature compensated crystal oscillator (TCXO) models designed specifically to be used in conjunction with a 0.1 Hz (and higher ) filter bandwidths for compliance with T1-based hierarchy specifications such as ITU-T G.8262 Option 1 and 2 ECC and ITU-T G.813 Option 1 and 2 SEC, Stratum 3 for Sonet, IEEE1588 and Synchronous Ethernet.
The new Connor-Winfield TCXO CSBxx Series is designed to be emergency beacon frequency references requiring tight ±0.2 ppm frequency stability and frequency slope control of only ±0.7 ppb/min. COSPAS-SARSAT beacons are battery operated emergency distress transmitters for locating ships or persons.
The OX200-SC is our most quiet, accurate and stable 10.0 MHz OCXO. The OX200-SC is designed for use in applications such as IP Backhaul using IEEE1588 PTP Master Clock that requires very high frequency stability, very tight initial calibration and very low aging. This may eliminate or greatly extend the time for initial or periodic re-calibration.
Connor-Winfield announces the release of the SFX-525G high precision frequency translator. This IC is well suited for use in line cards, service termination cards and similar functions to provide reliable reference, phase locked synchronization for TDM, PDH, SONET and SDH network equipment.
The Connor-Winfield Corporation is pleased to announce their newest 125 Series product the Xenith TBR (Model FTS500). The Xenith TBR is an OCXO based enclosed GPS disciplined clock and the ultimate timing device for DVB, DAB, wireless communication infrastructures, time-stamping or any other critical timing applications.
Connor-Winfield's new high stability SMD OH300 series of OCXOs provide an excellent capability to support IEEE 1588 system requirements. This SC crystal based design maximizes short term stability, frequency stability over temperature and extremely low aging rates.
Announcing our new STC5420 series of Timing Chips for SDH/SETS, SONET and Synchronous Ethernet This RoHS 6/6 compliant series are single chip clock synchronization solutions for applications in SDH/SETS, SONET and Synchronous Ethernet network elements.
Connor-Winfield's, low cost, high stability DOC Series of ovenized oscillators are exceptionally precise frequency standards, excellent for use in cellular base stations, test equipment, Synchronous Ethernet and VSAT applications.
Connor-Winfield announces a new high performance GPS disciplined oscillator, adding to the successful line of GPS driven timing and frequency products. The FTS375 is an OCXO based module that offers superior timing and frequency characteristics with outstanding phase noise and holdover in a compact, cost-effective design.
Connor-Winfield announces new GPS disciplined reference & synchronous clock generator, adding to their successful 125 Series of GPS driven timing and frequency products. The FTS250 is a TCXO based module that offers superior timing and frequency characteristics with low power consumption in a small, cost-effective design.
Through the use of Analog Temperature Compensation, the D32G series are capable of holding sub 1 ppm stabilities over the -30 to 85°C temperature range and are ideal for use in GPS receivers, instrumentation, Femtocell, FTTH & FTTC applications.
Please contact us for more information on any of the products listed here at literature@conwin.com.